Attached is the guide to set up the master Philips TV to connect to the internet

With the black guest remote, press MUTE LEFT RIGHT UP DOWN OK.

Once in Professional Settings, follow these steps:

1. Go to TV Settings>Sound>Sound Management>Headphone/Bathroom Speakers and turn it off.
2. Go to Advanced>Power>Standby Mode and set to Fast.
3. Go to Advanced>Security>ProIdiom and set it to Free to Guest.
4. Go to Wireless and Network>Connect to Network and press OK.
1. Select Wireless.
2. Select the WiFi name.
3. Press Finish when connection is complete
4. NOTE: If your Wireless Network redirects to a login page, connection is not possible. 

                                                              i.      Record the Wireless MAC address for all TVs.

                                                             ii.      This can be found on a label on the box or go to Professional Settings>Wireless and Networks>Settings>View Network Settings and press OK.

                                                           iii.      Provide this list to your Internet Service Provider and request that they Whitelist all the Wireless MAC addresses.

5. Go to Channels>RF Channel Installation and Press OK then select Start.
6. Go to Switch on Settings>Channel Settings>Switch on Channel and select the desired channel for the TV to turn onto.

Then to clone those settings to a thumb drive you can put in other TVs here are the instructions on making the clone and then using the clone.  The Upgrade and clone will be done in that same professional settings menu you make changes to above.

1. To clone these settings:
1. Put a FAT32 formatted USB drive into one of the two USB ports.
2. Go to Upgrade and Clone>Clone TV to USB>Clone All Except Apps and press OK.
2. To clone the settings above into other TVs:
1. Turn on the TV.
2. Put the USB drive into the TV when Instant Initial Cloning appears. 
3. If Instant Initial Cloning does not appear, go to Professional Settings>Upgrade and Clone>Clone USB to TV and press OK.